Once you remove the metallic frame then there is nothing to worry. You can remove those metallic frames with a U shaped wire that can be easily made at home. These metal plates are the main reason for the stability of the car stereo.Finally, once it is out of that very position, you can observe the metallic frames or clamps that hold it inside and makes it difficult to remove.While pulling it out, ensure that it should come out straight, otherwise it may break or get stuck. In addition, you will need to pull it out using both forceps simultaneously. Very carefully, pull it out while holding both forceps tight with your hands.Don’t rush at this point or it may get struck again. Hold the corners of the frames with these forceps and slowly move it out. Next, to remove the metal clamps that keep stereo fixed at a position, you will need two forceps.If still fails, you will have to pull out the metal that is holding it inside. Then, you pull the frame out by putting pressure on the knives. Let me explain it again, you can again use two knives and put them at the corners of the frames. NOTE: I have seen many fellows who just get stuck at this very step.
If so, you will need to detach those strings that normally maintain a strong support for the car stereo. Sometimes, there are strings attached to the internal sides of the car stereo that make it stable during installing. However, you have to be careful and take it slow to avoid breaking the frames. Note that here you will have to use a special technique: just push down and up, and then pull the internal plastic out. You can easily remover the inner plastic with your bare hands.Then, now that the external cover is removed, you should be able to see the inner plastic.However, please be careful, not to hurt yourself with the knives. This is a simple process and you can easily remove the external cover. NOTE: You have to use both knives simultaneously and push them into both sides of stereo to pull it out. Then, simply pull the external cover out with these knives. The knives should be sharp enough to penetrate the sides of the stereo. With these sharp knives, you will remove the external cover of the car stereo. Now, you will need to arrange two medium-sized kitchen knives for the first step.First, you will need to ensure that the car engine is switched off.For a double din stereo, I will post an article soon. Below, I have given detail of “How to Remove a Car Stereo Without Din Tools”.īest 6×9 Speakers – Top Rated Reviews Step by Step Guideīefore starting this guide, let me tell you, that this guide is focused on removing a single din car stereo. Follow this step by step and don’t rush into this.
With the help of the knives, remove the outer plastic and with forceps, remove the internal metallic part. Removing a car stereo without din tools is simple and you will only need two sharp knives, two forceps.
#1998 honda civic tapedeck replacment how to
How to Remove a Car Stereo Without Din Tools Read the whole article, before you finally decide to pull a shot. When I tried removing stereo?without tools, I did manage to remove it without any damage. Normally I don’t recommend removing stereo without a proper kit, without proper tools, you may damage the car stereo. Two months back, I decided to add this topic at Stereo Authority and on the same day, I used this method to remove a car stereo without din tools. I always recommend using proper tools and kits for the removal of a car stereo, however, this guide is focused, if you don’t have any din tools. You have bought a new car stereo but the problem is how to remove a car stereo without din tools.
0 kommentar(er)
